How to Use Falscara Lash Tools with Clear Bond

Quick Answer

Use the Falscara Lash Tools w/ Clear Bond Bundle to apply DIY lash extensions in five steps: prep, bond, apply wisps, seal, and remove. Focus on thin bond layers and proper placement for lasting wear.

How to Apply Falscara Lash Tools with Clear Bond

1. Prep Your Natural Lashes: Apply the Prep and Primer to your clean, dry lashes using the wand. This removes any oils or makeup residue so the bond can grip properly. Skipping this step is the most common cause of poor adhesion. Wait 30 seconds for it to dry before moving on.
2. Apply a Thin Layer of Clear Bond: Use the clear Bond side of the double-ended tube. Apply a thin, even coat along the underside of your natural lashes, close to the lash line but not on the skin. Too much bond creates a sticky mess and can cause wisps to slide. Less is more.
3. Place the Falscara Wisps Under Your Lashes: Using the Falscara applicator tool, pick up a wisp and gently press it against the underside of your natural lashes, starting at the outer corner. The bond should be tacky but not wet. If the bond is still wet, the wisp won't stay. Wait another 10-15 seconds until it becomes tacky.
4. Seal the Wisps with Seal: Flip the tube to the Seal side and apply a thin layer over the base of the wisps, where they meet your natural lashes. This locks the bond and adds a clear, glossy finish. Avoid getting seal on the lash hairs themselves — it can stiffen them and reduce flexibility.
5. Remove Gently at the End of Wear: Use the Falscara Remover or an oil-based makeup remover. Apply to a cotton pad and press against the lash line for 10-15 seconds. The wisps will slide off without pulling your natural lashes. Never pull or tug the wisps off dry — this can damage your natural lashes. Always dissolve the bond first.

Product Facts

• Falscara Lash Tools w/ Clear Bond Bundle: The bundle includes Prep and Primer infused with micellar water to cleanse natural lashes, plus Bond and Seal in a double-sided tube. Using the Prep and Primer removes oils and debris so the bond adheres better, helping your DIY lash extensions last longer.