Swan Lake Halloween Lashes and Gem Stickers: A Costume How-To

By Lashes, Nails, Textured Hair Products, Hair Care Tools | Kiss | Published: 2026-11-01

Category: How-to Guides

Layer the Kiss Swan Lake decorated false eyelashes and gem stickers for a costume-ready eye look. Follow these steps to place gems, blend the short strip, and avoid lifting.

Quick answer

Apply the Kiss Swan Lake lashes first, then add the gem stickers while the lash glue is still tacky but not wet. Keep gems on the lid and lash band, not on the lash hairs, so the short 7mm-11mm strip stays light and comfortable.

Why this short strip suits a Swan Lake costume

The Swan Lake pair is a medium-volume strip with a 7mm-11mm length range. That shorter range keeps the eye look soft and feathered rather than heavy, which fits a swan or lake-inspired costume better than a long, dense lash.

The pearl accents and gem stickers add the decorative detail, so you do not need to build a complicated eyeshadow look underneath. A simple wash of shadow and a thin liner gives the gems a clean base.

Where to place gems for a balanced look

Think of the gems as a small cluster near the outer corner and a single accent near the inner corner, not a full row across the lid. Butterfly and stud shapes can sit slightly above the lash band, while pearls look best close to the outer corner.

If your costume includes a mask or heavy face paint, keep gems off the moving part of the eyelid. Friction from a mask can loosen stickers during the night.

Step-by-step application

Prep the lid and lash band: Cleanse the eyelid and let it dry completely. Flex the lash band gently between your fingers a few times so it curves to your eye shape. Skip this and the band can poke at the inner corner or lift early.
Do a dry fit before gluing: Hold the strip against your lash line without glue. Trim only from the outer end if it extends past your eye, and check that the inner corner sits comfortably. Trimming too much from the inner corner makes the strip look short and can leave a gap.
Apply a thin line of lash glue: Run a thin bead of glue along the band and wait about 30 seconds until it becomes tacky. Too much glue makes the band slide and can smear your eye makeup. If the glue looks white and wet, it is not ready yet.
Place the strip and press: Set the strip at the center of your lash line first, then press the inner and outer corners down. Hold for a few seconds and check that both ends are secure. A lifted outer corner is the most common reason gems later slide off.
Add gem stickers last: Peel each gem sticker with tweezers and press it onto the lid or lash band, not onto the lash hairs. Start with the largest gem near the outer corner, then fill in with smaller studs and pearls. Placing gems on the lash hairs pulls the strip and can make it droop.
Seal and check: Press each gem firmly for a few seconds. Keep the eye closed and avoid rubbing. Check in a mirror under the same lighting you will have at the event. Carry the remaining stickers in a small bag for quick touch-ups.

Product facts

Kiss Halloween Decorated False Eyelashes & Gem Sticker - Swan Lake | 1 Pair, Strip Lashes, 7mm-11mm: One pair of 7mm-11mm medium-volume false eyelashes with pearl accents and decorative gem stickers in butterfly, stud, and pearl shapes. The short length keeps the strip comfortable for a full evening, while the included gem shapes let you match the decoration to your costume without buying extra stickers.
Kiss Halloween Decorated False Eyelashes & Gem Sticker - Swan Lake | 1 Pair, Strip Lashes, 7mm-11mm